Startech IDE2SAT

Cables : IDE : SKU: IDE2SAT

Thinking of making a large purchase?

Startech 2.5in and 3.5in 40 Pin Male IDE to SATA Adapter

$22.00

*FREE SHIPPING*

Free shipping to 48 states

Estimated Delivery with free shipping by:

* If ordered today with free shipping.

Connect your SATA drive to an IDE motherboard

Connect a SATA device to an IDE/ATA motherboard or controller card

Complete hardware solution; no software required

Support for 48-bit Logical Block Addressing (LBA)

Compliant with SATA revision 1.0 specification

Compatible with Ultra ATA 133 specification

Internal solution for connecting your SATA hard drive to a motherboard supporting an IDE interface

Ideal for use with older motherboards that do not support SATA

Lets you connect a SATA drive to a motherboard IDE/ATA 33/66/100/133 port

Effective solution for bridging the gap between a newer SATA drive and older motherboard designs

Allowing you to connected newer SATA drives to a older IDE motherboard port

Eliminating the need to upgrade the motherboard for the sake of compatibility with the drives

The IDE to SATA adapter can be connected through simple plug and play installation

Connect a SATA drive to an IDE system without having to install any special drivers or software

Lifetime Warranty

Chipset ID	Marvell - 88SA8052
Connector Type (1)	1 - IDE (40 Pin; EIDE/PATA) Male
Connector Type (2)	1 - SATA Data & Power Combo (7+15 pin) Receptacle
Connector Type (3)	1 - SP4 (4 pin; Small Drive Power) Male
Humidity	15~90% RH
Maximum Data Transfer Rate	133MB/sec
Operating Temperature	5°C to 50°C (40°F to 122°F)
Product Height	0.9 in [23 mm]
Product Length	3 in [75.5 mm]
Product Weight	0.5 oz [15 g]
Product Width	0.8 in [20 mm]
Shipping (Package) Weight	0.2 lb [0.1 kg]
Storage Temperature	-25°C to 80°C (-13°F to 176°F)
System and Cable Requirements	An IDE controller and ATA cable (not included).
Warranty	Lifetime

1 - IDE to SATA adapter

1 - LP4 Molex to SP4 Power Cable

1 - Instruction Manual